Checking The Signal Cable
- Ignition off.
Check the signal cables below for both the rear doors. Check for a short-circuit to supply voltage. Check for an open-circuit. Check for a short-circuit to ground.
- Between lock unit connector terminal #3 and the relay holder in the door, terminal #4
- Between the relay holder in the door, terminal #3 and rear electronic module (REM) relay position 2/115 terminal #3.
Remedy as necessary.
Other information:
- To access the lock unit in the rear door, see LOCK MECHANISM REAR SIDE DOOR, REPLACING
- To access the integrated relay/fusebox in the cargo compartment:
- For -2004, see: RELAY/FUSE BOX CARGO COMPARTMENT/REAR ELECTRONIC MODULE (REM), REPLACING
- For 2005-, see: REAR ELECTRONIC MODULE (REM), REPLACING .
- see CHECKING WIRING AND TERMINALS .
- Continue
Refer to VERIFICATION
- Ignition off.
Check the signal cables below for both the rear doors. Check for a short-circuit to supply voltage. Check for an open-circuit. Check for a short-circuit to ground.
- Between the relay holder in the door, terminal #2 and ground
- Between the relay holder in the door, terminal #1 and central electronic module (CEM) relay position 2/120 terminal #3.
Remedy as necessary.
Other information:
- To access the central electronic module (CEM), see CENTRAL ELECTRONIC MODULE (CEM), REPLACING
- To connect the breakout box, see CONNECTING THE BREAKOUT BOX
- see CHECKING WIRING AND TERMINALS .
- Continue
Refer to VERIFICATION