Checking / Setting Turbo2 Pressure Regulator: Finishing

Fig 1: Identifying Split Pin From Lever And Push Rod

Courtesy of VOLVO CARS CORPORATION

Install the split pin on the lever.

Tighten the locknut on the lever.

Remove the test equipment.

Fig 2: Charge Air And Intake Pipes

Courtesy of VOLVO CARS CORPORATION

Install 

• the heat deflector plate over the turbocharger (TC). Tighten to 25 Nm 
• the charge air and intake pipes to the turbocharger (TC). Align against the plastic pipes and tighten.

Lower the car.

Fig 3: Engine And Stabilizer Brace

Courtesy of VOLVO CARS CORPORATION

• the engine stabilizer brace between the suspension turrets. Tighten the screws at the suspension turret. Tighten to 50 Nm 
• the screw for the engine stabilizer brace mounting on the engine. Tighten to 80 Nm  .

Press the plastic pipes into place and tighten the clamps.

• the mounting screws for plastic pipes and tighten
• the hoses from the pressure regulators to the T piece.