Positioning The Stop Button

Fig 1: Checking Belt Does Not Fray When Spike On Stop Is Pressed Through Belt

Courtesy of VOLVO CARS CORPORATION

This method covers all stops positioned on seat belts in the vehicle.

The stop must be positioned in the center of the belt at a distance of XXXX mm from the end mounting. See STOP BUTTON SEAT BELT, SPECIFICATIONS .

Check that the belt does not fray when the spike on the stop is pressed through the belt.

Thread the cover onto the stop.

Fig 2: Checking That Belt Does Not Fray When Spike On Stop Is Pressed Through Belt

Courtesy of VOLVO CARS CORPORATION

Press the sections together as much as possible.

HINT: Hold the cover in place so that there is no gap. Use round-nosed pliers.

WARNING:

The seat belt material must not be overheated or it will melt. If this happens, the entire seat belt must be replaced.

Fig 3: Heating Using A Soldering Iron Or A Hot Air Gun Equipped With A Long Narrow Nozzle

Courtesy of VOLVO CARS CORPORATION

Heat using a soldering iron or a hot air gun equipped with a long narrow nozzle. Heat until the spike melts and the sections cannot be separated. Hold in place until the material has cooled down.

Check that the stop is secure and cannot be pulled off.