Master Cylinder, Brake: Installation
For tightening torques, see: TIGHTENING TORQUE .
INSTALLING MASTER CYLINDER
Install:
- the two brake pipes. Tighten. See: TIGHTENING TORQUE
- the 2 nuts. Tighten. See: TIGHTENING TORQUE
- the connector on the brake fluid reservoir.
BLEEDING BRAKE SYSTEMS
Bleed the brake system. See: BRAKE SYSTEM BLEEDING .
Check that the brake pipe connections are sealed.
Check the brake fluid level.
INSTALLING MASTER CYLINDER
For tightening torques, see: TIGHTENING TORQUE .
Install:
- the 2 brake pipes. Tighten. See: TIGHTENING TORQUE
- the 2 M8 nuts
- the connector on the brake fluid reservoir
- the feeder hose for the clutch cylinder.
BLEEDING BRAKE SYSTEMS
Bleed the brake system. See: BRAKE SYSTEM BLEEDING .
Check that the brake pipe connections are sealed.
Check the brake fluid level.
INSTALLING THE PROTECTIVE COVERS
Install:
- the protective cover for the firewall
- the plastic nut, x 1.
Install the protective cover over the brake fluid reservoir. Carefully lift up the cowl. Install the 2 clips for the protective cover.
Install the 3 clips holding the cowl.
Make sure that the seal is correctly located.
To install, reverse the removal procedure.
Perform bleeding air brake system, see BRAKE SYSTEM BLEEDING