Installing The Muffler

Only applies at the first change when the joint between the front and center mufflers is missing. 

Install: 

• the front muffler. Use a new flange gasket
• the 2 x M10 nuts. Do not tighten yet
• the center muffler
• the M10 nut for the clamp between the front and center muffler. Do not tighten yet
• the M10 nut for the clamp between the rear and center muffler. Do not tighten yet
• the rubber mountings.

Adjust the position of the exhaust pipe. Tighten the 4 x M10 nuts.

Applies to the second or later changes. 

Install: 

• the front muffler. Use a new flange gasket
• the 2 x M10 nuts. Do not tighten yet
• the M10 nut for the clamp between the front and center muffler.

Adjust the position of the exhaust pipe. Tighten the 3 x M10 nuts.