Checking Wiring

Check the signal cable between the headlamp washer relay and the washer motor. Check for an open-circuit. Check for a short-circuit to ground.

Take readings between:

• The headlamp washer relay connector terminal #5 and washer motor connector terminal #1.

Remedy as necessary.

Other information 

• see CONNECTING THE BREAKOUT BOX (2008, 2009, 2010, 2011)
• see SIGNAL DESCRIPTION CENTRAL ELECTRONIC MODULE (CEM) (2008, 2009, 2010, 2011)
• see CONTROL MODULE RELAY BOX PASSENGER COMPARTMENT
• see CHECKING WIRING AND TERMINALS

Was a fault detected? 

• YES 

  Refer to VERIFICATION 

• NO 

  Refer to REPLACING WASHER MOTOR