Fault-Tracing Information

The headlamp washer motors are supplied with power via a relay positioned in the integrated relay/fusebox in the engine compartment.

Reasons for the headlamp washers not working can include:

Burnt out fuse
Damaged relay
The washer reservoir level is too low
Open-circuit in the signal cable
Defective washer motor.
Headlamps off (Only applies to vehicles with Halogen lamps).
Low voltage in the battery and engine not running (Only applies to vehicles with Bi-Xenon lamps).

NOTE:

The headlamp washer is only activated every 5th time that the stalk for windshield washing/headlamp washing is activated. The counter for this activation is reset after 10 minutes.

Continue
Refer to CHECKING COMPONENTS

The fault should have been detected and remedied. As this is not the case fault-tracing has failed.

Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.