CEM-AFF1: Localization Failed (2008-2011): Fault-Tracing: Verification: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Reinstall the connectors, components etc.
• Ignition on.

  Read off the last stored ID number by clicking on the VCT2000 symbol. The last stored ID number is displayed until a new ID number is received and stored.

  NOTE:

  The last stored value is erased when the ignition is switched off and on again.

  Use the following special tools to activate the sensor.

  • 9512987

  The special tool activates the sensor which starts to send information to the central electronic module (CEM) and the sensor's id-number can then be read in the upper character window  .

  NOTE:

  Ensure that the special tool is positioned under the edge of the rim against the tire where the sensor is installed. The sensor will not be activated if the tool is against the rim. The sensor must then be held in place for approximately 5 seconds for the signals to be correctly received.

  Use only one special tool at a time in the vicinity of the car.

  NOTE:

  Carry out the above in an area away from where other cars are being driven. The receiver can pick up signals from sensors on other cars. An incorrect ID number would then be displayed.

  Check that the relevant sensor(s) respond. Test different wheels to ensure that different ID numbers are displayed.

  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 4: Identifying Special Tool

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the sensor OK? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to INFORMATION