Checking Component And Wiring

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Light switch in position 0
• Disconnect connector A and connector B to the right-hand gas discharge lamp module (GDL).

  Check the connectors for contact resistance and oxidation. Check for damage carefully.

  Check the following signal cables between the right-hand gas discharge lamp module (GDL) and the right-hand lamp housing. Check for an open-circuit. Check for a short-circuit to ground.

  Take readings between:

  • Gas discharge lamp module (GDL) terminal #B3 and lamp housing terminal #2
  • Gas discharge lamp module (GDL) terminal #B4 and lamp housing terminal #8.

  Check the signal cable between the central electronic module (CEM) and the right-hand gas discharge lamp module (GDL). Check for an open-circuit. Check for a short-circuit to ground.

  Take readings between:

  • Central electronic module (CEM) terminal #E11 (#A11) and gas discharge lamp module (GDL) terminal #A5.

  Check the signal cable between the central electronic module (CEM) and the right-hand lamp housing. Check for an open-circuit. Check for a short-circuit to ground.

  Take readings between:

  • Central electronic module (CEM) terminal #E11 (#A11) and lamp housing terminal #3.

  Remedy as necessary.

  Other information: 

  • see CONNECTING THE BREAKOUT BOX (2004, 2005, 2006, 2007)
  • see SIGNAL DESCRIPTION CENTRAL ELECTRONIC MODULE (CEM) (2004, 2005, 2006, 2007)
  • see LOCATION OF COMPONENTS (2004, 2005, 2006, 2007)
  • see CONTROL MODULE RELAY BOX PASSENGER COMPARTMENT
  • see HEADLAMP BALLAST (XENON) (2004, 2005, 2006, 2007)
  • see CHECKING WIRING AND TERMINALS
  Fig 2: Identifying 8-Bit Connector

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 3: Identifying 6-Bit Connector

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected? 

• YES 

  Refer to VERIFICATION 

• NO 

  Refer to REPLACING LEFT-HAND LAMP HOUSING