Checking Component

Check that the right-hand gas discharge lamp module (GDL) has not been installed on the left-hand side.

If a new gas discharge lamp module (GDL) has been installed, the vehicle information must be programmed.

To program the gas discharge lamp module (GDL) with vehicle parameters and to calibrate the position sensor, see CALIBRATION OF POSITION SENSOR, GDL LAMPS .

Remedy as necessary.

Other information: 

• see CONNECTING THE BREAKOUT BOX (2004, 2005, 2006, 2007)
• see SIGNAL DESCRIPTION CENTRAL ELECTRONIC MODULE (CEM) (2004, 2005, 2006, 2007)
• see LOCATION OF COMPONENTS (2004, 2005, 2006, 2007)
• see CONTROL MODULE RELAY BOX PASSENGER COMPARTMENT
• see HEADLAMP BALLAST (XENON) (2004, 2005, 2006, 2007)
• see CHECKING WIRING AND TERMINALS

Fig 1: Identifying Right-Hand Gas Discharge Lamp Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to VERIFICATION