Checking Component And Wiring
- Ignition off
- Light switch in position 0
- Disconnect the left-hand gas discharge lamp module (GDL) connector A.
Check that the ignition module in the lamp housing is correctly installed.
Check that the bulb in the lamp housing is correctly installed.
Check the connectors for contact resistance and oxidation. Check for damage carefully.
Remedy as necessary.
Other information:
- see CONNECTING THE BREAKOUT BOX (2004, 2005, 2006, 2007)
- see SIGNAL DESCRIPTION CENTRAL ELECTRONIC MODULE (CEM) (2004, 2005, 2006, 2007)
- see LOCATION OF COMPONENTS (2004, 2005, 2006, 2007)
- see CONTROL MODULE RELAY BOX PASSENGER COMPARTMENT
- see HEADLAMP BULB (XENON) (2004, 2005, 2006, 2007)
- see CHECKING WIRING AND TERMINALS
Was a fault detected?
- YES
Refer to VERIFICATION
- NO
Refer to REPLACING BULB