Calibrating The Component

Check that the position sensors are correctly installed.

Ensure that the car is unladen and is on a flat surface.

To program the gas discharge lamp module (GDL) with vehicle parameters and to calibrate the position sensor, see CALIBRATION OF POSITION SENSOR, GDL LAMPS .

Other information: 

• see CONNECTING THE BREAKOUT BOX (2004, 2005, 2006, 2007)
• see SIGNAL DESCRIPTION CENTRAL ELECTRONIC MODULE (CEM) (2004, 2005, 2006, 2007)
• see CONTROL MODULE RELAY BOX PASSENGER COMPARTMENT
• see POSITION SENSOR REAR, HEADLAMP (2004, 2005, 2006, 2007)
• see CHECKING WIRING AND TERMINALS

Fig 1: Identifying Light Switch

Courtesy of VOLVO CARS OF NORTH AMERICA.

Refer to VERIFICATION