Parking Assistance, Rear: Notes
- Clean the sensors. Use: Isopropanol.
- Allow to dry.
- Carefully mat down the surface. Use Glasspaper, grade P1000.
- Clean the sensors again. Use: Isopropanol.
- Allow to dry.
- Avoid contact with the cleaned surfaces.
- Clean the cradles. Use: Isopropanol.
- Allow to dry.
- Avoid contact with the cleaned surfaces.
- Apply a thin and even layer of primer to the cleaned plastic surface.CAUTION:
Not on the center of the sensor.
Use: Bonding primer for plastic. P/N: 31335448.
HINT: Spray primer into the cap of the can and apply with a brush.
CAUTION:Allow to dry at a temperature of at least +20°C for 10 min, before painting.
NOTE:
Also read the instructions on the spray can.
- Apply primer to the cleaned surface. Use: Bonding primer for plastic. P/N: 31335448.CAUTION:
Allow to dry at a temperature of at least +20°C for 10 min, before painting.
NOTE:
Also read the instructions on the spray can.