Installing The Control Arm

NOTE:

For tightening torques, See: TIGHTENING TORQUE .

Install:

the control arm
the screw x1 for the sub-frame. Do not tighten yet
the screw for the wheel spindle. Do not tighten yet.

NOTE:

The rear suspension must be in normal position when tightening all the joints in the rear suspension where rubber bushings are involved, See:NORMAL POSITION .

Tighten the screws. For tightening torques, See: TIGHTENING TORQUE .

CAUTION:

Use a transmission jack to avoid damaging to the screws.