Front Fender: Installation
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Clean the inside of the front fender and the mating surface on the bodywork.
Rust-proof the cleaned components.
Locate the front fender in the correct position.
Install:
- the screw behind the hinge for the front side door. Tighten the screw by hand
- the foam seal
- the two screws at the bottom. Finger tighten
- the three screws at the top. Finger tighten
- the screw (1) at the front. Finger tighten
- the screw for the bumper and fender.
NOTE:
Tighten the top screws first.
Check the alignment of the fender against the car body.
Tighten all screws. Tighten to 6 Nm .
Install:
- the side turn signal flashers on the fender
- the turn signal lamp unit
- the screw for the turn signal lamp unit
- the fender liner according to Plastic fender liner .