Installing the support member

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Support Member And Heat Deflector Plate

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

The support member under the engine, 4 screws
front edge, long screws

Rear edge, short screws

Tighten to: 70 Nm

Support member - engine, 2 screws. Use new lock nuts . Tighten the rear nut first, then the front.

Tighten to: 50 Nm
The heat deflector plate, 3 screws.