Removing the drive shaft
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Turn the wheel (turning to the right)
Angle the stub axle and remove the drive shaft from the hub and gear box.
CAUTION:
Do not damage the seal in the hub.
Temporarily secure the stub axle to the spring strut with one of the screws.
Install the seal plug 9995488 in the gearbox.
CAUTION:
Ensure that no dirt enters the hub bearing.