Removing the drive shaft from the hub

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Drive Shaft Splines

Courtesy of VOLVO CARS OF NORTH AMERICA.

(Image left hand side).

Turn the wheel (turning to the left)

Angle out the stub axle. Detach the drive shaft from the hub.

WARNING: Do not damage the seal in the hub.

Clean the splined joint.

CAUTION: Tighten the constant velocity joint, when the shaft is removed. This is to help prevent excessive load on the joint axial stop. Take care not to damage the drive shaft seal and boots.