Installing the drive shaft, stub axle, brake hose and ABS sensor

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Drive Shaft, Stub Axle, Brake Hose And ABS Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

(Image left hand side.)

Align the drive shaft in the hub

Install:

The screws for the stub axle with new lock nuts
Torque: 90 Nm .
The brake hose with the retaining clip on the spring strut
the ABS sensor
the ABS line to the spring strut.

Install a new lock nut on the drive shaft.

Finger tighten the nut.