Adjustment Of Light Propagation: Adjustment

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Cover

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition and low beam on.
CAUTION: Always adjust the light propagation with low beam on.
Check the amperage so there are enough current for correct light propagation
Undo the cap.

Fig 2: Adjusting Headlamp Alignment

Courtesy of VOLVO CARS OF NORTH AMERICA.

Adjust the light propagation in vertical height (Y) by using a socket screw as shown.
Adjust the light propagation laterally (X) by using a socket screw.
HINT: Use socket screw 6 mm.

Fig 3: Adjusting Headlamp Light Distribution

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Headlamp beam adjustment must be carried out according to the relevant national statutory requirements.