Windshield installation
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Apply PUR adhesive according to PUR .
Fold back the cable connectors for the heated rear windshield.
Position the windshield.
Secure the strips of tape to the window.
Push the window down by hand if any further height adjustment is required.
Make sure that the rubber seal is positioned firmly against the body.
Leak test
NOTE:
Allow the adhesive to cure so that the window does not change position before installing the components.