Installing the trim molding
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Clean the surface from grease and dust. Use white spirit.
WARNING:
Avoid skin contact with the white spirit.
Check that the bodywork is at room temperature.
Heat the trim molding and double-sided adhesive tape to 40°C.
Remove the protective film from the tape.
Position the molding at points A, B and C.
Press the molding into place.