LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2008 >> S40 T-5, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Climate Units - General Information (644 Body)) >> Air Conditioning (B4204T3 (Ca) (Us), L. H. D; 2001-2003) >> Refrigerant Reservoir >> Removing And Installing the Refrigerant Reservoir >> Transferring the Support To the New Refrigerant Reservoir

Transferring the Support To the New Refrigerant Reservoir

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Mark the position of the support on the old refrigerant reservoir.

Remove the screw for the clamp.

Remove the support.

Transfer the marking from the old refrigerant reservoir to the new.

Install the support.

Slide the rubber in between the refrigerant reservoir and the clamp for the support.

Tighten the screw for the clamp by hand.

Transfer the pressure sensor (Pressostat) to the new refrigerant reservoir.

Lubricate the O-rings using compressor oil.

Tighten the screw. Tighten to 18 Nm  .

scientia non olet · About LEMON Manuals