Checking the control module connector

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition OFF

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 2: Disconnecting Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Ignition off
Disconnect the breakout box.
Expose and disconnect the connector from the ABS control module.
Check the cable terminals in both the female and male halves of the control module connector.
Check the male and female halves of the connector. Check that they lock to each other when connected.

Check the connector cable terminals, female and male halves, 24/22 and 24/13.

Are the male and female halves OK?

YES
Refer to Checking wheel bearings
NO
Refer to Replacing the component