Replacing the trip computer switch

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Knobs From Heater Control And Inserting Small Screwdriver At Rear Edge Under Each Knob

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the knobs from the heater control; insert a small screwdriver at the rear edge under each knob.
Remove the heater control panel (insert two fingers into the opening and carefully pull out the control panel).
Remove the four torx mounting screws.

Fig 2: Removing Rear Section Of Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the rear section of the bracket. Carefully press the edge with a screwdriver.

NOTE: The radio must be pulled forward a few centimeters before the rear section of the bracket can be removed.

Remove the screws behind the rear section of the bracket. Pull the bracket forward slightly.
Press in the retaining clips on the reverse of the trip computer switch.

Reinstall the components in reverse order.