Checking the wiring

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off
Check the signal cable between engine control module (ECM) terminal 36 and DSA control module terminal 5 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults
Remedy as necessary.
Other information:
- To connect the engine control module (ECM) breakout box, see Connecting the breakout box. EMS 2000
- For connecting DSA control module breakout box, see Connecting the breakout box. DSA
- For information about signals, see Signal specification .
Fig 2: DSA Control Module Terminals
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying EMS2000
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Verification