Faulty signal. Permanent fault: Verification
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
HINT: After carrying out the repair, check that the fault has been remedied.
- Raise the car so that the drive wheels are clear of the ground. Ensure that the car is secure.
- Start the engine and let it idle.
- Activate reading off the vehicle speed: Click on the VCT 2000 symbol.
- Shift gear selector to position D so that the drive wheels begin to rotate
Depress the accelerator pedal (AP) and check that the speed is updated.
NOTE:Ensure that the wheels are not rotating when the gear selector is moved.
NOTE:Diagnostic trouble codes (DTCs) may be stored in the ABS system when the rear wheels are stationary and the front wheels rotate.
Was the signal updated?
- YES
OKAY: Troubleshooting has been completed.
- NO
Refer to Information