Diagnostic trouble code (DTC) information
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Condition
At engine startup the control module checks that the camshaft is in the correct position in relation to the crankshaft. Diagnostic trouble code (DTC) ECM-62 is stored if the control module detects the camshaft in an incorrect position on start up.
Substitute Value
None.
Possible Source
- Camshaft cogs incorrectly seated
- Incorrectly installed camshaft pulley
- Contact resistance in the terminals.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit
- The engine misfires.