Diagnostic trouble code (DTC) information
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Condition
Each time that the engine is switched off the camshaft pulley sets itself in the locked position. The control module checks that the camshaft pulley leaves the locked position when the engine is started again. Diagnostic trouble code (DTC) ECM-61 is stored if the control module detects that the camshaft pulley is in the locked position.
Substitute Value
None.
Possible Source
- Low oil pressure in the engine
- Blocked oil ducts for the camshaft reset valve
- Defective camshaft reset valve.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.