Checking components and wiring

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Check that the resistance in the canister purge (CP) valve between terminals #1 and #2 is approximately 21 Ω at +20 °C.

Check the signal cable between engine control module (ECM) terminal 4 and canister purge (CP) valve terminal #1. Check for an intermittent short-circuit to supply voltage according to Short-circuit to supply voltage, intermittent faults . Remedy if necessary.

Other information

To connect the breakout box, see Connecting the breakout box. EMS 2000 .

Fig 1: Identifying Canister Purge (CP) Valve Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying EMS2000

Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Information