Checking wiring and components

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Check the signal cable between ignition coil terminal 1 and engine control module (ECM) terminal #32 (ECM-38), #1 (ECM-3A) for an intermittent short-circuit to supply voltage and remedy according to Short-circuit to supply voltage, intermittent faults .

If no faults are found in the above fault-tracing try a new ignition coil.

Other information

To connect the breakout box, see Connecting the breakout box. EMS 2000 .
To replace the ignition coil see Ignition coil(s), replacement .

Fig 1: Identifying EMS2000

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Voltage Display

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Outside Temperature Sensor Connector Terminal 2

Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Information