Checking cables

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Check the cable between connector terminal 2 for the camshaft position (CMP) sensor and engine control module (ECM) connector terminal 58. Check the cable connector terminal 3 for the camshaft position (CMP) sensor (control module side) and engine control module (ECM) terminal 83. Check these cables for an open-circuit according to Open-circuit, permanent faults and for a short-circuit to ground according to Short-circuit to ground, permanent faults and for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .

Remedy as necessary.

Fig 1: Identifying EMS2000

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Camshaft Position (CMP) Sensor Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Verification