LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2008 >> S40 T-5, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Electronic Control Module (ECM) Diagnostic Trouble Codes - 1 Of 3 (644 Body)) >> ECM-24: System Relay Control Signal. Signal Too Low. Intermittent Fault (B4204T3; 2004) >> Signal too low. Intermittent fault >> Checking wiring

Checking wiring

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Check the signal cable between engine control module (ECM) terminal #10 and system relay terminal #2. Check for an intermittent short-circuit to ground Short-circuit to ground, intermittent faults . Check for an open-circuit according to Open-circuit, intermittent faults . Remedy if necessary.

Try a new system relay if no fault is found during the above fault-tracing.

Other information 

Fig 1: Identifying System Relay Control Connector Terminals
GLL114473Courtesy of VOLVO CARS OF NORTH AMERICA.
Fig 2: Identifying Ohmmeter
GLL101042Courtesy of VOLVO CARS OF NORTH AMERICA.
Fig 3: Identifying EMS2000
GLL111998Courtesy of VOLVO CARS OF NORTH AMERICA.