LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2008 >> S40 T-5, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Electronic Control Module (ECM) Diagnostic Trouble Codes - 1 Of 3 (644 Body)) >> ECM-1E: Injector 1. Signal Too High. Intermittent Fault (B4204T2 CVVT; 2000) >> Signal too high. Intermittent fault >> Checking wiring

Checking wiring

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Check the signal cable between the engine control module (ECM) terminal #59 and injector terminal #2 for an intermittent short-circuit to supply voltage. Remedy according to Short-circuit to supply voltage, intermittent faults .

Try a new injector if no faults are found in the above fault-tracing.

Other information 

Fig 1: Identifying Injector Connector Terminals
GLL112386Courtesy of VOLVO CARS OF NORTH AMERICA.
Fig 2: Identifying Ohmmeter
GLL101042Courtesy of VOLVO CARS OF NORTH AMERICA.
Fig 3: Identifying Injector Wiring Diagram
GLL112200Courtesy of VOLVO CARS OF NORTH AMERICA.