Tighten and fit parts from the top

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Front Engine-Bay Cover, EVAP Hose, Intake Air Temperature (IAT) Sensor Connector, Right Side Fan Connector & Bolts

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the holder and fit the two bolts. Tighten to 10 Nm
Install the EVAP valve and fit the connector
Connect the fan connectors
Tighten the cables and tie up
Connect the cable of the intake air temperature (IAT) sensor.

Check the function and install the front engine-bay cover.