Installing the vibration damper

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Vibration Damper & Counterhold 9995433

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the vibration damper.

Tighten the center nut to 180 Nm .

Use counterhold 9995433 .

Remove the counterhold. Tighten the screws. Tighten to 25 Nm .

Angle-tighten 30° . Use bevel protractor 9512050 .