Exposing the cable harness
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Remove:
- the screw from the ignition coil ground
- the camshaft position (CMP) sensor.
Remove:
- the variable valve timing valve connector
- the ignition coil connectors.
Place the cable harness to one side.
Unscrew the cable duct from the rear edge of the cylinder head and the throttle body (TB) bracket. Release the rear edge of the cylinder head from the cables and hoses.
Remove:
- the connector for the engine coolant temperature sensor
- the injector connectors.
Place the cable duct and cable harness to one side.
Mark up and remove the ignition coils and ignition cables.
Remove:
- the rear cover for the camshaft
- the camshaft position (CMP) sensor housing
- the trigger wheel.