Replacing the camshaft seals: Finishing

Fig 1: Removing/Installing Metal Bracket For Servo Hose

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the lifting beam and lifting hook.

Tighten the engine mounting nut. Tighten to 98 Nm  .

Install: 

• the power steering reservoir
• the metal bracket for the power steering hose on the rotation protection for the auxiliaries belt
• the auxiliaries belt
• the rear camshaft cover
• the trigger wheel. Tighten to 17 Nm 
• the camshaft position (CMP) sensor housing. Tighten to 5 Nm 
• the cable duct
• the brake servo vacuum hose
• the hose between the intake manifold and air cleaner (ACL) housing
• the blind cover plug
• the mounting screws for the starter motor
• the support between the cylinder block and the intake manifold
• the front air baffle
• the cable from the battery negative terminal. First read Note when disconnecting and connecting the battery lead .