Installing the rear engine mounting

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Rear Engine Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the engine mounting with the hole pointing backwards
the screws (C). Tighten to 35 Nm
the screw and the nut (B). Tighten by hand
the screws (A). Tighten to 69 Nm .

NOTE: Ensure that the bushings are correctly positioned (as shown).

Remove the screw (B) for the front engine mounting.

Tighten the rear screw first, then the front screw. Tighten to 55 Nm .

Install:

the heat deflector plate
the parallel strut for the front suspension.