Components, installing

Fig 1: Removing/Installing Cable Harness

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the ignition coils and ignition cables according to earlier markings.
• the ignition coils' ground cable.
• the camshaft position sensor.

Lay the cable channel and cable harness in place.

Install: 

• the cable channel's screws on the cylinder head's trailing edge and the throttle housing's console.
• console between inlet pipe and servo pump.
• injectors' connectors.
• water temperature sensor's connector.
• air preheating hose between air filter and exhaust manifold's heat shield plate.
• the auxiliaries belt
• the pipe screw for the water-heated crankcase ventilation.
• air filter housing's top part complete with hose.
• EVAP-valve's connection to mass air flow sensor's hose.
• the mass air flow sensor's connector.
• the turbo control valve on the air filter housing.
• brake servo's vacuum hose.
• throttle cable.
• the inlet hose between mass air flow sensor and throttle housing.
• the front timing cover.
• the cover over the ignition coils.
• the upper timing cover
• the cover over the throttle housing.
• the cover over the injectors