Cable harness, exposing
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Remove:
- the screw from the ignition coils' ground.
- the camshaft position sensor.
Remove:
- the ignition coils' connectors.
Place the cable harness to the side.
Screw loose the cable channel from the cylinder head's trailing edge and the throttle housing's console. Disconnect cables and hoses from the cylinder head's trailing edge.
Remove:
- water temperature sensor's connector.
- injectors' connectors.
Lay the cable channel and cable harness to the side.
Mark up and remove ignition coils and ignition cables.
Remove:
- camshaft's rear cover.
- the camshaft position (CMP) sensor housing
- the trigger wheel.