Camshaft seals, replacing: Finishing
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Remove lifting beam and lifting hook.
Install:
- the servo reservoir.
- servo hose's metal console on the auxiliary unit belt's rotation guard.
- the auxiliaries belt
- turbo engines: right engine protection cover as well as the cover over right headlight unit.
- rear camshaft cover.
- blinder. Tightening torque 17 Nm .
- camshaft sensor housing. Tightening torque 5 Nm .
- cable channel.
- brake servo's vacuum hose.
- hose between inlet pipe and air filter housing.
- the blind cover plug.
- the starter motor mounting screws.
- the support between the cylinder block and the intake manifold.
- front air baffle.
- the cable from the battery's negative terminal. First read Note when disconnecting and connecting the battery lead .