Activating Components/Functions
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To activate components, the engine must be idling. Activation occurs for approximately 20 seconds.
NOTE:
After Activation is completed, the DSA function is disconnected. The DSA function is re-engaged using the DSA switch. If no diagnostic trouble codes (DTCs) have been stored, the DSA warning lamp goes out after engagement.
| No. | Component/function | Remarks |
|---|---|---|
| 1 | TOR LIMIT | Torque limiting for anti-spin control. Level 4 request for torque limiting to the engine control module (ECM). Level 4 means that the same cylinder is shut off four times during four cycles, i e. all the time. The engine idles unevenly. The DSA warning lamp flashes during this activation. |
| 2 | W/LAMP FLASH | The indicator lamp and DSA warning lamp in the combined instrument panel. The DSA warning lamp flashes at a frequency of 1.8 Hz. |