LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2008 >> S40 T-5, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Dynamic Stability Assist (DSA) & Electronic Control Module (ECM) Diagnostic Trouble Codes (644 Body)) >> ECM-13: Mass Air Flow (MAF) Sensor Signal. Signal Too Low. Permanent Fault (B4204T2 CVVT; 2000) >> Signal too low. Permanent fault >> Checking wiring and terminals

Checking wiring and terminals

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Check the cable between mass air flow (MAF) sensor connector terminal #3 (engine control module (ECM) side) and system relay 2/14 base terminal #5 for an open-circuit according to Open-circuit, permanent faults .

Remedy as necessary.

Fig 1: Identifying Atmospheric Pressure Sensor Connector Terminals
GLL111982Courtesy of VOLVO CARS OF NORTH AMERICA.
Fig 2: Identifying Ohmmeter
GLL101042Courtesy of VOLVO CARS OF NORTH AMERICA.
Fig 3: Identifying System Relay Base Terminals
GLL114196Courtesy of VOLVO CARS OF NORTH AMERICA.