LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2008 >> S40 T-5, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Dynamic Stability Assist (DSA) & Electronic Control Module (ECM) Diagnostic Trouble Codes (644 Body)) >> DSA-212: Stop (Brake) Lamp Switch. Faulty Signal. Permanent Fault (B4204T2 CVVT; 2000) >> Faulty signal. Permanent fault >> Fault cause and checking for contact resistance and oxidation

Fault cause and checking for contact resistance and oxidation

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

The cause of the diagnostic trouble code (DTC) was loose connections in the DSA control module connector.

Check the control module connector for contact resistance and oxidation and remedy according to Contact resistance and oxidation .

scientia non olet · About LEMON Manuals