Replacing printed circuit board
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the black protection at the top on the left. Disconnect the connector.
- Remove the temperature module (2 mounting screws).
- Remove the lamps.
- Remove the screws from the speedometer and the tachometer.
- Carefully remove the printed circuit board.
Ensure that the correct buttons are in the correct position on the front.