Longitudinal member, installing
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Install the longitudinal member (A) and tighten to 69 Nm . Fit the two screws (B) through the engine pads.
NOTE:
Position the engine pad rubber at the correct spot. See illustration (the front and rear engine pads are positioned on the member in the same manner).
NOTE:
The screw of the front engine pad is longer.
Tighten the front engine pad nut (B) finger-tight. First tighten the rear engine pad nut to 59 Nm . Then tighten the front engine pad nut to 59 Nm .
Install the heat deflector plate on the rear bracket.