Install the torque converter screws

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Torque Converter Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Use new screws, Torx TX50.

Align the torque converter against the carrier plate. Do this by turning the engine with the nut for the crankshaft pulley and turning the torque converter.

Install all 6 screws loosely. Tighten the screws until the heads are in contact with the carrier plate. Then tighten to 35 Nm . Use Torx socket TX50

NOTE:

Remove the socket wrench from the crankshaft.