Install and tighten the screws for the transmission

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Gearbox Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install all 7 screws for the transmission / engine.

First tighten alternately and crosswise to light contact.

At the same time, check that the whole of the transmission is in contact with the engine.

Then tighten the screws crosswise. Tighten the screws for the transmission and engine. Tighten to 50 Nm . Tighten the screws for the starter motor. Tighten to 40 Nm .

Remove the fixture from the transmission.