Drive shaft and stub axle, installing

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Drive Shaft And Stub Axle Installation

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the mobile jack 9985972 as a support under the control arm.

Align the drive shaft in the hub
Lubricate the shaft splines using grease, P/N 1161246-2.

Install:

the new screws for the stub axle. Use new lock nuts. Tighten to 90 Nm
counterhold 9995683
the drive shaft nut. Lubricate the nut before installing. Tighten. See Centre nut, drive shaft and tightening torque . Remove the counterhold.